Why the published numbers are so far apart
Each source prices a different job. Read them for what they include:
- Homewyse prices basic labor with favorable site conditions and lightweight manufactured stone panels in 6 × 24 inch interlocking units. It leaves out general contractor overhead (add 13% to 22%), permit fees, sales tax on materials and any repair to the framing behind the wall.
- This Old House uses Angi and HomeAdvisor data for stone veneer siding and lists the extras separately: a new moisture barrier at $2 to $4 per sq ft, $3 to $4 per sq ft more to take off old siding that has lath or anchors, and $9,900 to $17,900 if the underlayment has to be replaced in full.
- Cost vs. Value prices one defined job in each market: a 300 sq ft band of vinyl siding taken off the bottom third of the street-facing front and replaced with adhered manufactured stone, with 36 linear feet of sills, 40 linear feet of corners, an address block, an outlined entry arch with a keystone, two separate layers of water-resistive barrier, corrosion-resistant lath and a half-inch scratch coat.
- Stone makers price their own products. Affinity Stone, which sells screw-on panels, estimates a small house front of about 350 sq ft at $5,250 to $7,000 for a wainscot-style install. Evolve Stone puts traditional veneer at $15 to $27 per sq ft with installation, and easy-install panels like its own at $12 to $20.
Evolve Stone also tells you to plan for two things the per-square-foot figures leave out: 5% to 10% extra stone for cuts and breakage, and a 10% to 15% contingency for hidden water damage or repairs to the wall underneath. Corners are sold by the linear foot, not the square foot, so count them separately.
What has to go behind the stone
Most of a veneer price is the wall you never see. New Jersey adopted the 2024 International Residential Code as its one- and two-family dwelling subcode (N.J.A.C. 5:23-3.21), and the state's list of changes there leaves the wall covering section alone. Its rules for adhered veneer on a framed wall (section R703.12):
- Keep it off the ground. At least 4 inches above the earth, 2 inches above paving, or half an inch above a walking surface that sits on the same foundation as the wall.
- A screed or flashing at the bottom. Corrosion-resistant, with a vertical flange of at least 3½ inches, reaching at least 1 inch below the foundation plate line.
- A water-resistive barrier behind it. A listed barrier that laps over the flange of that screed, so water that gets behind the stone drains out at the bottom.
- Lath, or the maker's method. The veneer goes up over corrosion-resistant lath fastened to the framing (section R703.7.1), to the TMS 602 masonry standard, or to the manufacturer's instructions. Over masonry or concrete prepared to the standard, lath is not required.
Why it matters: Penn State's housing research center calls manufactured stone a “reservoir cladding” whose walls “must be designed with performance and durability in mind,” and expects continued wall failures to keep changing the code. It describes a rainscreen as an air space of 1/4 to 3/4 inch behind the cladding, with openings at the top and bottom, that helps a wet wall dry (PHRC, 2019).
On a block or poured concrete wall the job is simpler. Quarry Mill says its natural thin stone can be mortared directly to a block wall with no wire mesh or scratch coat, straight onto a clean poured concrete wall, and indoors onto cement board.
Manufactured or natural stone
Manufactured stone is cement with lightweight aggregate, molded and tinted to look like stone; natural thin veneer is real stone cut thin. This Old House's cost per square foot by material:
| Material | Per sq ft |
|---|---|
| Manufactured stone | $5–$8 |
| Faux stone (vinyl, resin or foam) | $6–$9 |
| Stone-look vinyl | $5–$10 |
| Slate | $4.50–$10 |
| Basalt | $7–$11 |
| Granite | $15–$30 |
| Limestone | $20–$28 |
- Weight: a This Old House mason puts normal brick or stone at over 60 pounds a square foot and veneer at 15, which he says alleviates the need for a foundation.
- Speed: a skilled mason with an assistant can lay only 15 to 20 sq ft of fieldstone a day (This Old House). Quarry Mill adds that small or irregular stones take longer, and a mortarless drystack joint usually costs more than a standard half-inch joint.
- Repairs: This Old House warns that a discontinued manufactured product is hard to match, and its magazine that one good bump can reveal artificial stone's weakness.

Stone veneer or brick veneer?
On Homewyse's own basic estimates, stone veneer is the dearer of the two: $23.62 to $42.50 per sq ft (August 2026) against $14.99 to $24.05 for brick veneer siding (May 2026). Homewyse prices that brick line with a faux-brick interlocking panel as the material, so a full-depth brick wall is a different number again. For lifespan, InterNACHI's chart puts brick, natural stone and veneer at 100+ years.

House fronts, garages and chimneys
Affinity Stone publishes job-size estimates for its own screw-on panels, installed wainscot-style rather than full height (updated August 27, 2026). Per square foot they work out to $15 to $20:
| Job | Affinity's estimate |
|---|---|
| Garage front, about 250 sq ft | $3,750–$5,000 |
| Small house front, about 350 sq ft | $5,250–$7,000 |
| Chimney, about 400 sq ft | $6,000–$8,000 |
| Medium house front, about 650 sq ft | $9,750–$13,000 |
| Large house front, 1,000+ sq ft | $15,000+ |
A fireplace inside is the simplest wall of all: Quarry Mill calls cement board the easiest base indoors, and the only place a construction adhesive is acceptable for its stone. A chimney outside is a height job: Evolve Stone lists height and scaffold or lift needs among what drives labor, which it calls often the largest part of a veneer budget.

New Jersey: the permit and the sales tax
A permit, unlike siding
New Jersey treats the repair or replacement of siding on a one- or two-family home as ordinary maintenance, with no permit (N.J.A.C. 5:23-2.7). Stone is not in that list. The Department of Community Affairs said so plainly: stucco, stone, cultured stone and brick “are not specific siding materials listed as ordinary maintenance, and permits ARE required for their replacement or installation” (Construction Code Communicator, Summer 2018). Ask your town's construction office to confirm before work starts.
Sales tax
- New Jersey defines a capital improvement as an installation, permanently attached, that increases the capital value or useful life of a building, and lists new siding and a fireplace among its exempt examples (S&U-3).
- On an exempt capital improvement, give the contractor a completed Form ST-8 and the labor on the bill is not taxed. The contractor pays the sales tax on materials when buying them.
- A repair is different: its labor is taxed, and pointing bricks is one of the state's own examples of a repair.
New Jersey moved to the 2024 codes on August 17, 2026. What changed, and the last day to file under the old ones, is on our 2024 building code page.
Does a stone front pay you back?
In the 2025 Cost vs. Value report, manufactured stone veneer ranked third of 28 projects nationally for value kept at resale, behind a garage door and a steel entry door. The same 300 sq ft job, by market:
| Market | Job cost | Resale value | Recouped |
|---|---|---|---|
| New York, NY | $13,332 | $25,705 | 192.8% |
| Middle Atlantic region | $13,251 | $26,598 | 200.7% |
| National average | $11,702 | $24,328 | 207.9% |
Zonda, the report's publisher, says the results come partly from surveys of real estate professionals and partly from Verisk's XactRemodel cost data (Zonda). Read the resale column as the report's estimate, not a measured sale price, for the job above, water barrier included.
What to ask before you sign
- Is the price for the stone going up, or for the whole wall: old siding off, barrier, lath, scratch coat, screed, stone, corners and sills?
- How many layers of water-resistive barrier, and is there a drainage gap or rainscreen?
- Where does the stone stop: at least 4 inches above the soil and 2 inches above the driveway or walk?
- How are the windows, doors and the top edge flashed?
- Which stone, how many linear feet of corners, and how much extra for cuts?
- Who files the permit, and is the labor billed separately so your ST-8 covers it?
- Is the contractor registered? Every home improvement contractor in New Jersey has a registration number for the contract. How to check it.
Veneer and facade work with AB in Essex County
Veneer and facade work is part of our masonry services, with block foundations, brick steps and retaining walls, for homes and commercial buildings. On the Abuelo's Steakhouse job in Bloomfield our crew took the old stone and brick facade apart before rebuilding the storefront. Our office is on Newark Avenue in Belleville, and we work across Essex, Union and Passaic counties. We don't publish a veneer price per square foot: put the wall's size in the estimate form, or call -331-0796.

